How do effects loops on amps work

Thanks for responding. And there begins my dilemma. The Boogie has a dedicated output jack which is a stereo signal. That output signal is going straight to the guitar input of the second amp. Again, thanks for your input no pun intended Rick. I see your conundrum here.

I took a look at the Grand Canyon and was hoping that it had a stereo input, but nope mono. Which is going to send me into a whole other rant that is for another post. But not going to work in this scenario. But not sure if that will take away from the effect you are getting from the go. Option 2 is get a stereo sum pedal. It basically acts like a mixer to feed two separate legs of a stereo split into one. Technically you could get away with a cheap 2 ch mixer.

But then you have gain levels to worry about. These types of pedals keep it simple. Notify me of follow-up comments by email. Notify me of new posts by email. This site uses Akismet to reduce spam. Keep in mind that this is an extremely basic example of the signal flow through an amplifier and as you can imagine, there are several amps out there that house additional functionality and complications.

The front input is ideal for pedals that are meant to alter the entire signal as its fed into the amp prior to pre-amplification. There are also other pedals that would work well here, such as a Wah-wah, Flanger, Phaser, and Chorus. Additionally, there are also other pedals that can be used here, such as reverb, delay, and tremolo.

They would ideally process the signal after your In-Line Effects. This would be a fine solution if you just using the clean channel on your amp exclusively. Have a listen to the following audio clips. The first clip is an A chord being played through a distortion pedal which is then fed through a delay pedal and finally routed to the front input on the amp with the clean channel selected.

It might sound cool as a texture to add periodically into your tone say for a solo , but when playing with a full band, it can tend to hurt the overall sound and tight rhythm. What is a guitar amp effects loop? Featured Products. The difference between an effects loop and going into the front of an amp. But what do you do if you use your amp for distortion and not pedals?

Should I use overdrive or distortion in the effects loop? Should I put Delay or Reverb first in the effects loop? So, to answer the question, should I use an effects loop? Power amps do not affect the tone in a noticeable way, in most cases they are designed to be transparent.

You have a reverb pedal and you connected your guitar to this pedal and then connected its output to the guitar amplifiers input. Now your guitar signal first arrives at the reverb pedal , your tone gets reverbized and then it arrives at the preamp of the amplifier where the amp gives you overdrive. Now you are overdriving a clean signal with reverb. If you would like to have your sound overdriven first and then you wanna add reverb to that overdriven sound, you would need to place your reverb pedal after the preamp.

This is where FX loop saves you. You should connect your reverb pedal to the FX loop section of your amp FX send into the pedal input, and pedal output to the FX return and now your reverb pedal is placed after the preamp. Now you can connect your guitar directly into your amplifier , get any tone you want from the amp and your reverb pedal will affect the tone after the signal passes the amplifiers tone stack. Because giving overdrive to a reverbed guitar and giving reverb to an overdriven guitar are two different sounds.

Using the same guitar effects does not give the same results when you place them in different orders and the FX loop lets you insert guitar effects after the amp. You can learn more about the orders of the effects in the signal chain in this post. Download Deplike, the best Guitar Effects App. Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website.